Add additional control over the configuration of "points of calibration"

Currently when setting up a Calibration program the user is able to configure their own specific points of calibration, however it is limited to numeric values only. It would be helpful if the user could have the option to enter alpha-numeric "points", and also select the order in which these points will be displayed when the record is added as currently the software automatically arranges these points from lowest-highest values.

  • Gravatar Guest
  • Oct 14 2015
  • Will not implement
  • Oct 30, 2015

    Admin Response

    The ability to add non-numeric calibration checks? The ability to order checks as you wish? This sounds awfully like the Monitoring module. Suggest using the Monitoring module for these calibrations. The proposed changes are unlikely to ever be made to the Calibration module when the Monitoring module can do this and much more.

  • Attach files
  • Guest commented
    November 5, 2015 19:48

    I agree, and the Monitoring Module is already more than capable of handling this. The downfall to that is that the calibration program is then sitting outside of the Calibration Module, and any calibrations completed on a particular item will not automatically be linked to the device (see attached screenshot). Regarding the "Alpha-Numeric" points, I suppose it would be better suited to have an additional line specification for calibrations where multiple points (Left Front, Right Rear, etc.) would be required. Either this lines would need have the capability to be ordered, or the user would simply need to adopt a naming convention that would maintain the order after the auto-sequencing. 

  • Gravatar
  • Gravatar
  • Gravatar
  • Gravatar
  • Gravatar
  • Gravatar
  • Gravatar
  • Gravatar
  • Gravatar